Loop systems for the hard of hearing, allowing the hearing impaired to hear clearly.  

Overton Electrical Services Ltd have over 30 years of experience within the care home industry and can provide a range of services for the deaf and hard of hearing . We can supply and maintain induction loops to aid persons with hearing aids, and also vibrating and flashing beacons to alert the deaf and hard of hearing that a fire alarm or other alert has been raised.

Audio-Frequency Induction Loop Systems Loop systems

Audio-frequency induction loop systems (AFILS) allow hearing impaired people to hear more clearly. Most hearing aids have a ‘T’ or ‘MT’ switch which allows them to pick up the electromagnetic field generated by an induction loop system. The hearing aid converts this signal into a sound suited to its user’s specific hearing requirements. Any person with a hearing aid positioned within or near the loop can hear the loop signal by switching their hearing aid to the correct position, allowing them to participate more effectively in general conversation, ordering goods or services, listening to public performances, etc.

Overton’s PDA range of induction loop equipment is one of the most comprehensive in the UK. It comprises a huge range of amplifiers, microphones, connector plates and test equipment covering virtually every conceivable AFILS application.

Amplifiers

Designed to meet or exceed the requirements of BS7594 and EN60118-4 when correctly installed, all amplifiers in the PDA range offer excellent intelligibility, true current mode amplification, phantom power (for electret microphones) and full compatibility with our ‘outreach plate’ audio input extension system (except the PL1, VL1 and DL50). Many are also available in kit format for ease of specification, purchase and installation.

Outreach Plate Audio Input Extension System

The Outreach Plate audio input extension system comprises a range of wall, ceiling and desk mountable single gang audio input plates specifically designed to increase the audio input capability of an induction loop system. Covering the most common variants of audio connector, they work by mixing the signals from various audio input sources into one balanced line level input which can be fed into the line input of a compatible amplifier.

Mountable on 25mm single gang back boxes, each plate features a built-in mixer, pre-amp, input level control and balanced output.

Typically, up to 10 Outreach plates (any mix) can be daisy-chained to one balanced line level input with cable lengths of up to 100m easily achievable using standard two-pair audio cable with no recognisable degradation of audio signal quality.

Each outreach plate requires four wires, two balanced line (A+, A–), one ground (0V) and one power connection (12-32 V DC regulated). To facilitate their straightforward connection, most PDA Range amplifiers are fitted with an Outreach connection socket as standard.

Induction Loop Cable

There is nothing electrically special about induction loop cable. Almost any stranded or solid single core cable with tough insulation can be used, provided it is not liable to break (to minimise the chance of it shorting to earth and damaging the amplifier’s output) and is of the appropriate gauge and DC resistance (0.5 to 1 Ohm). If purchasing a PDA Range induction loop kit, always use the loop cable supplied with the kit.

Microphones

Electret microphones have the highest tolerance of magnetic feedback and are therefore recommended for induction loop systems. Dynamic microphones should not be used as they contain moving coil magnets which can be affected by the magnetic field generated by the loop. Phantom power is provided on all PDArange amplifiers, so electret microphones with internal batteries are not necessary.

Call Overton Electrical Services Ltd now your electrical specialists in the care industry with over 30 years experience. Tel: 01623 632302 or use our eForm

Overton Electrical Services